Viking Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Cleaned out the belt and clutch housing but now the unit wont go over 30mph.. Oil is clean any idea where to start troubleshooting?
50451
 

·
Registered
Joined
·
6,007 Posts
I think we need a lot more details about the situation and behavior.

Sent from my SAMSUNG-SM-G890A using Tapatalk
 

·
Registered
Joined
·
31 Posts
Cleaned out the belt and clutch housing but now the unit wont go over 30mph.. Oil is clean any idea where to start troubleshooting?
Explain "cleaned out the belt and Clutch Housing". Did you clean out the primary? Looks like you probably got mud in there! 😁
 

·
Super Moderator
Joined
·
4,115 Posts
Was it fine until you cleaned it out? Belt stretched?
 

·
Registered
Joined
·
31 Posts
Check your air filter. One of the guys in my group also driving a Viking couldn’t get his much higher than that in speed earlier this week. Found air filter soaking wet and some water standing in the bottom of the housing from playing in to much water. After drying filter out and draining water ran just fine.
 

·
Super Moderator
Joined
·
4,115 Posts
^^^^^ good point!
 

·
Registered
Joined
·
6,007 Posts
I had that problem. At low speed it was fine. At high throttle it would sag.

Sent from my SAMSUNG-SM-G890A using Tapatalk
 
1 - 9 of 9 Posts
Top