Viking Forum banner
1 - 6 of 6 Posts

· Registered
Joined
·
25 Posts
Discussion Starter · #1 ·
After installing the wet clutch I took a 1/4" round punch and staked the (new) wet clutch nut.
After done beating on it, mine has like 2 big dents in the nut rim of the nut, and I was looking at a picture of someone elses staked nut and theirs is beat totally flat, should I be worried mine might loosen? I would think any kind of bend would keep it from turning. Any thoughts? Thanks
 

· Registered
2020 Yamaha Viking EPS
Joined
·
1,629 Posts
Probably fine, post a picture of it though that might help.
 

· Registered
Joined
·
25 Posts
Discussion Starter · #4 ·
Well, not going to be able to do that, because it is all closed up and already took it down the road.
If I had it still open, I would beat it down more flatter, and not worry about it. Thanks for responding though.
 

· Super Moderator
Joined
·
5,195 Posts
As above, Buck's right. It'll be a nightmare to pull apart again if you over beat it.
 
1 - 6 of 6 Posts
Top