Viking Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
I just received the Seizmik door and rear window kit for my 2016 Viking. For the life of me, I cannot figure out how to properly hang the door on this thing. Could someone be so kind to post photos (drivers side preferably) of the hinge and Z bracket/bar mounting locations? Also, I cannot figure out how to properly position the clamp that mounts on the top roll bar that secures the top of the Z bracket/bar. Cannot wait to get this installed!!
 

·
Registered
Joined
·
29 Posts
Here you go hope this helps. Also i put the back of cab in front of the sound panel. I think mine cab was made for earlier models that did not have this panel.
 

Attachments

·
Registered
Joined
·
8 Posts
Discussion Starter #3
Thank you! There is supposed to be an open air gap between the door and frame when closed right? Also, did you remove the sound dampener panel when installing the back?
 

·
Registered
Joined
·
29 Posts
There is a little gap but not much. Probably more on top. You can swing the hinge piece in a little to close gap more. It takes some time making little adjustments even bending door frame a little here and a little there to get things just right. As far as the sound damping panel goes ended up leaving mine in place but pulled seats out so i could install back in front of it. I know i had to cut some slits in it to get everything attached again. Its a little tight this way but it worked out. I think these were originally designed for machines with out the sound damping panel. All in all i really like mine!
 
  • Like
Reactions: cactus
1 - 4 of 4 Posts
Top