[ROOSTER26]

My rear frame tubes were constantly holding mud. I would have to spray water in over the the end caps, and then have to bend down the the skid plate for it to run out. Now, no more bending of the skid to drain out.

Sent from my iPad using Tapatalk

 

[aronsrb]

Did you make this, and are you going to sell them

Sent from my SAMSUNG-SM-N900A using Tapatalk

 

[ROOSTER26]

I just took a small angle grinder to it. Only took 5 min to do.

 

[aronsrb]

I see now, I thought you made a new one out of steel

Sent from my SAMSUNG-SM-N900A using Tapatalk

 

[cheeyz]

so you just cut it open?

 

[ROOSTER26]

Yes. It works great.

 

[akrider]

Excellent mod. Any issues when backing out of tough spots ?

 

[VikingRyder]

Great mod.

 

[ROOSTER26]

No issues yet. The frame tubes haven't held any mud after the mod, but I haven't had to back up In any mud...yet. I kept the holes small as to not grab to much mud in reverse.

 

[vixx]

yea thats what I was thinking about getting mud up into the frame. Although I suppose the issue was water staying in there so thats resolved...