Viking Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter #1
Hey guys,

I am in the process of replacing my drivers side lower control arm. I got it the old one off fairly easy, but am unsure of how to get the new one back on the lower ball joint. Forgive me, I haven't done this type of job before. I am hoping I don't have to take anything else apart, and it'll go back on as it's sitting. Just want to make sure I get it back in the new control arm correctly. Any tips?
 

·
Super Moderator
Joined
·
4,284 Posts
Just mount your control arm to the chassis then put the spigot on the ball joint into the control arm and do the nut up. Or are you replacing the ball joint too? you might need a jack under the steering knuckle to make it all line up.
 
  • Like
Reactions: kynknwl
1 - 2 of 2 Posts
Top