Viking Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
Looking for a flush mount rocker switch that will work for a champion 4500 pound winch. Anyone know of a good one?
 

·
Registered
Joined
·
6,152 Posts
Any winch switch should work since it is only carrying the load of the relay. I'd look on Amazon.

Sent from my SM-F707U using Tapatalk
 

·
Registered
2020 Yamaha Viking EPS
Joined
·
414 Posts
This is a KFI switch
5503EA86-334E-4B6E-BDB4-66E0E219B7BA.jpeg
 

·
Registered
2020 Yamaha Viking EPS
Joined
·
414 Posts
Yes It should
 

·
Registered
2020 Yamaha Viking EPS
Joined
·
414 Posts
I wish my switch was “in” at the top and “out” on the bottom. It would just make more sense when lifting and lowering the snowplow.
 

·
Registered
Joined
·
117 Posts
I wish my switch was “in” at the top and “out” on the bottom. It would just make more sense when lifting and lowering the snowplow.
Put the switch in upside down... 🤪
 
  • Like
Reactions: cactus

·
Registered
2020 Yamaha Viking EPS
Joined
·
414 Posts

·
Registered
Joined
·
85 Posts
I recommend an ON/OFF switch somewhere to turn on and off the winch. My nephew likes to climb in my CovidZombieKiller and flip the switches. If the winch was always active then there is a good chance he would unwind the winch without pulling the cable, or even over tighten the cable. Thankfully there is a hidden on/off switch he doesn't know about. He can turn on and off the lights, and whips all he wants for all I care.

Cheap insurance.
 

·
Super Moderator
Joined
·
4,377 Posts
1 - 12 of 12 Posts
Top