Viking Forum banner
1 - 12 of 12 Posts

·
Registered
2015 Viking EPS
Joined
·
5 Posts
Discussion Starter · #1 ·
Hello, I’m able to get a smokin deal on a set of 26x10-12 tires. I know they will fit but was hoping someone would have a picture with 26” tires. I hate the look of the 25” go kart tires it came with and really like the look of 27’s. Hoping the 26’s will make it look a decent amount better, but can’t find any pictures. Thanks!
 

·
Registered
2020 Yamaha Viking EPS
Joined
·
1,517 Posts
Welcome to the forum. Are you going to put those 26x10’s on front and rear? What brand and model of tire are you getting? The original tires by Maxis run small as do most of the Maxis atv/UTV tires. And sorry no pictures I’m still running the original tires. Other than the smallish look they work great.
 

·
Registered
2015 Viking EPS
Joined
·
5 Posts
Discussion Starter · #3 ·
Thanks! The tires are the pro armor harvester. Would run same size all the way around. My OE big horns are about worn out and have plugs in two of the tires. I do a decent amount of road riding and the harvesters are 10ply. I was leaning towards terrabites but can get the harvesters for about $300 cheaper.
 

·
Registered
2020 Yamaha Viking EPS
Joined
·
1,517 Posts
Ok, Not familiar with those tires.
I’m assuming you’re putting them on the original wheels. If so I would make sure the 10” wide tires will fit on the smaller front wheels. I think they will, 10” maybe as wide as you can go.
 

·
Registered
Joined
·
577 Posts
Awesome! Thanks for the reply and the additional picture! On a side note, how did you fabricate the upper half’s to your factory doors? It amazes me that there isn’t an aftermarket kit that makes the doors whole instead of having to purchase very sendy half doors.
i used some 1' trubeing for the frame and bolted it to the door panel.i will try to find some pics of the inner door.i don't know how the original doors pass a safety inspection..
 

·
Registered
2015 Viking EPS
Joined
·
5 Posts
Discussion Starter · #10 ·
i used some 1' trubeing for the frame and bolted it to the door panel.i will try to find some pics of the inner door.i don't know how the original doors pass a safety inspection..

Thanks! That would be great. I think they are only meant to keep your legs in in case of a roll over. Same with your arms and the shoulder pads. Still better then the stupid nets everyone else is using, but I would be willing to pay the little bit extra it would have cost for Yamaha to make the doors into full half’s.
 

·
Registered
Joined
·
577 Posts
Thanks! That would be great. I think they are only meant to keep your legs in in case of a roll over. Same with your arms and the shoulder pads. Still better then the stupid nets everyone else is using, but I would be willing to pay the little bit extra it would have cost for Yamaha to make the doors into full half’s.
brush and snow is an issue on the trails where i ride,so i need all the protection i can get,getting slapped in the face with willows isn't much fun.
 

·
Registered
Joined
·
577 Posts
Thanks! That would be great. I think they are only meant to keep your legs in in case of a roll over. Same with your arms and the shoulder pads. Still better then the stupid nets everyone else is using, but I would be willing to pay the little bit extra it would have cost for Yamaha to make the doors into full half’s.
 

Attachments

1 - 12 of 12 Posts
Top