52" led light bar roof install and 4" lights on rear
Just finished installing a 52" light bar on top of the roof and two 4" led lights on the back tubing that the headrest are on. I have to start by saying this wasn't easy like I thought it was going to be. The light bars support brackets were to short since the roof slopes down on the edges. After fabricating some 1" steel shims and not liking the way it looked I went to fastenal and bought some 1/4" washers and used three of them to shim under the brackets then I used two more between the roof and the roll cage. I drilled a 5/16 hole through the roof and top roll tube then replaced the bolt they sent me with a Alan head 4 1/2" bolt and used a nylon nut to secure it. The 4" lights on the back were a lot easier I just replaced the bolt they sent with a longer one and drilled a 5/16 hole then bolted them on. I ran all the wiring inside the roll cage tubing and used 1/2" braided wire loom tubing anywhere wires would be exposed. Then wired them into the rocker switches I had previously installed when I added the stereo. If anyone has any questions about anything I have posted please feel free to ask. Thanks to everyone else on here for there advise and ideas also.
Last edited by Warfrat; 03-30-2017 at 09:59 PM.